Embroidered patches can be dated all the way back to ancient Asian civilizations; they’ve been around for hundreds of years. Yet not until recently has it been possible to place them to your clothing using a hot iron and heat-activated glue. With today’s patches you can readily apply them on most fabrics without ever needing a needle and thread. Thankfully having the ability to affix them with a hot iron implies that the fingers are not going to get sore and it is much easier and quicker to do. The only issue is, you can’t iron patches to leather – at least within the traditional sense.
When you’re utilizing a hot iron to attach embroidered patches you’re essentially heating up the glue on the back side till it reaches a semi liquid, tacky state. That needs a great number of heat; heat that can damage the sensitive finish of leather.
It’s true that leather is an extremely durable material, nevertheless the surface is comfortably damaged by concentrated heat sources. This presents two problems. The initial problem would be the fact if the leather is damaged, the glue will not stick to it and then the patch will fall off. And once the patch does fall off, the leather will likely be left having an ugly mark where the iron has burned it. The same can probably be said for vinyl and various faux leather. One more thing to consider is that even if you might find a way to make the glue adhere, one slip of the iron that can bring in contact with bare leather will leave a burn mark. This is the reason you need to not have a hot iron anywhere near your leather.
We said earlier that you simply can’t use an iron to set embroidered patches to leather in the traditional sense. The explanation for saying it is because that while you should not try to place iron on patches to leather inside the traditional way but there’s a non-traditional method. Therefore there is special glue that can be used along with an unheated iron. Yes, a smeynb iron. It are only important to apply your iron being a press.
In order to get this to work properly, you will have to have special glue; leather is notoriously difficult to do business with so that you won’t have the capacity to use just any old glue. You can get this specialized glue at craft stores, sewing shops, and also some high-end leather goods specialty stores. Just be sure you carefully read the directions on the bottle, being sure that use on leather products is specifically mentioned. Failure to get this done could suggest that you’re just going to be squandering your money.
The glue must be placed on the rear of the patch depending on the instructions on the bottle and you should carefully position the patch on the portion of the leather in which you want to buy. Next thing you have to do is make use of your cold iron to press down firmly on the patch for the amount of time as mentioned on the glue bottle. You may then release the iron and wait for glue to dry. It’s essential you know where you want to have your patch prior to deciding to lay it down. You will end up left with an ugly stain should you remove the patch after you might have placed it on the leather.